|
|
|
Bi-Xenon Conversion for Pre-Facelift X5 (E53)
Introduction:
For a while now I have been interested in upgrading my pre-facelift BMW X5 (E53) headlights from Xenon to Bi-Xenon, but only with best quality OEM type parts. After much research, quite some trial and error, and some dead-ends, I fou 
|
Posted by allisong
- Last Activity 02-09-2008 04:21 PM
by allisong 
|
|
|
|
|
|
|
Running angel eyes as daytime running lights<o></o>
<o></o>
Objective: To have the Angel Eyes work as daytime running lights.<o>
</o><o></o>
I wanted to make this project as simple and economic as possible while keeping the option to revert everything back with minim
|
Posted by SuaveX5
- Last Activity 06-09-2007 09:22 PM
by SuaveX5
|
|
|
|
|
|
|
I got many requests about this, so here it is:
Total time: 15 minutes or less.
2007 X5 (E70) uses H11 bulbs.
NO TOOLS REQUIRED!! :D
1. Remove the cover by pulling down the top and out on the silver trim piece. Start from outside of the car and move in. You will need to wiggle it to loosen t
|
Posted by X5 Boy
- Last Activity 03-31-2007 10:14 PM
by X5 Boy
|
|
|
|
|
|
|
Changing Xenon bulbs in an E53 X5
|
Posted by Zulu95
- Last Activity 12-11-2006 10:05 PM
by Zulu95
|
|
|
|
|
|
|
http://www.x5world.com/docs/E53HeadlightWiringPlug.doc
Plug Unit Pin Out From Rear
1 2 3 4 5 <O:p</O:p
○○○○○
○○○○○○○<O:p</O:p
6 7 8 9 10 11 12
<O:p</O:pWiring layout:
|
Posted by Zulu95
- Last Activity 11-09-2006 08:29 PM
by Zulu95
|
|
|
|
|
|
|
ANGEL EYES WIRING DIY - 2000-2003 X5
The pic below is the wire/relay harness from the Predator chromiums and I numbered each connection with a corresponding description/where to connect info.
http://i22.photobucket.com/albums/b332/iop9000/AEwireharnessMedium.jpg
KEY:
1. Relay - to be mount
|
Posted by iop9000
- Last Activity 04-21-2006 06:29 PM
by imaznumkay
|
|
|
|
|
|
|
Contributed by: imaznumkay
When i had my angel eyes i looked EVERYWHERE inside the hood to feed my remote wire to the footwell...well i found this long time ago but i just took some pics for yall and here it is :D
You should see a rubber grommet driver side under t
|
Posted by imaznumkay
- Last Activity 01-21-2006 09:08 PM
by imaznumkay
|
|
|
|
|
|
|
Front Turn Signal Replacement
(for '04 +, see bottom of page)
Excerpted from posts by TripleX5, TommyX, jlzander and UCrewX5
Tools Needed:
|
Posted by UCrewX5
- Last Activity 01-19-2006 09:33 PM
by UCrewX5
|
|
|
|
|
|
|
2004 Euro BMW X5 with 4.6is / 4.8is trim
|
Posted by X5world
- Last Activity 01-09-2006 11:05 AM
by X5world
|
|
|
|
|
|
|
Contributed by: X5World
Installing Angel Eyes in a 2000 - 2002 BMW X5
Follow these steps to first to remove the light assemblies from the vehicle - http://www.x5world.com/showarticle-63.html
Once the headlights are out, place them on a clean work surface.
Follow these steps to open up t
|
Posted by X5world
- Last Activity 01-09-2006 11:05 AM
by X5world
|
|
